3M™ Flange Adapter- 6 in Radial Bristle Brush Set, 2 in x 1 in, 25 ea/Case
3M™ Flange Adapter- 6 in Radial Bristle Brush Set, 2 in x 1 in, 25 ea/Case
3M™ Flange Adapter- 6 in Radial Bristle Brush Set, 2 in x 1 in, 25 ea/Case
SKU
#7000028515
Part #: 27628
Call for Availability
For industrial/occupational use only. Not for consumer sale or use.
For industrial/occupational use only. Not for consumer sale or use.
3M industrial and occupational products are intended, labeled, and
packaged for sale to trained industrial and occupational customers for
workplace use. Unless specifically stated otherwise on the applicable
product packaging or literature, these products are not intended,
labeled, or packaged for sale to or use by consumers (e.g., for home,
personal, primary or secondary school, recreational/sporting, or other
uses not described in the applicable product packaging or literature),
and must be selected and used in compliance with applicable health and
safety regulations and standards (e.g., U.S. OSHA, ANSI), as well as all
product literature, user instructions, warnings, and other limitations,
and the user must take any action required under any recall, field
action, or other product use notice. Misuse of 3M industrial and
occupational products may result in injury, sickness, death, or property
damage. For help with product selection and use, consult your on-site
safety professional, industrial hygienist, or other subject matter
expert.
3M™ Flange Adapter holds together a minimum of seven 6 inch radial bristle discs for use on bench motors with a shaft size of 1 inch diameter.
For bench motors with shafts smaller than 1 inch, a 3M™ Telescoping Wheel Flange Adapter (Part No. 5) can be inserted into the center hole to fit 1/2 inch, 5/8 inch, 3/4 inch or 7/8 inch shafts. When a greater thickness of bristle discs is needed, 3M™ Spindle Extender Adapters (Part No. 30134) can be added to increase the disc capacity of the flange adapter. These additional adapters are sold separately.
Two-piece flange adapter holds a minimum of 7 bristle discs
1 inch hole optimizes mounting of 6 inch bristle discs on bench motors with a 1 inch diameter shaft
3M™ Telescoping Wheel Flange Adapter (Part No. 5, sold separately) can be inserted in the center hole to adapt to shaft sizes as small as 1/2 inch diameter
Can be used with one or more 3M™ Spindle Extender Adapters (Part No. 30134, sold separately) when additional layers of bristle discs are required