3M™ Thin Flexographic Plate Mounting Tape E2105, Translucent, 18 in x 36 yd, 5 mil, 1 roll per case
3M™ Thin Flexographic Plate Mounting Tape E2105, Translucent, 18 in x 36 yd, 5 mil, 1 roll per case
3M™ Thin Flexographic Plate Mounting Tape E2105, Translucent, 18 in x 36 yd, 5 mil, 1 roll per case
SKU
#7100074253
Call for Availability
For industrial/occupational use only. Not for consumer sale or use.
For industrial/occupational use only. Not for consumer sale or use.
3M industrial and occupational products are intended, labeled, and
packaged for sale to trained industrial and occupational customers for
workplace use. Unless specifically stated otherwise on the applicable
product packaging or literature, these products are not intended,
labeled, or packaged for sale to or use by consumers (e.g., for home,
personal, primary or secondary school, recreational/sporting, or other
uses not described in the applicable product packaging or literature),
and must be selected and used in compliance with applicable health and
safety regulations and standards (e.g., U.S. OSHA, ANSI), as well as all
product literature, user instructions, warnings, and other limitations,
and the user must take any action required under any recall, field
action, or other product use notice. Misuse of 3M industrial and
occupational products may result in injury, sickness, death, or property
damage. For help with product selection and use, consult your on-site
safety professional, industrial hygienist, or other subject matter
expert.
3M™ Thin Flexographic Plate Mounting Tape E2105 is a double coated film tape constructed of a polyester film carrier with differential adhesives. It is specifically designed for mounting flexographic print plates to cushioned or compressible sleeves.
Mount Flexographic Plates with Confidence3M™ Thin Flexographic Plate Mounting Tape E2105 is a double coated tape that has the air release feature designed to allow air to escape from between the tape and the plate. This crosshatched pattern creates a continuous and permanent network of micro-channels, allowing air to escape from between the tape and plate. It features excellent holding power on-press with easy and clean plate removal when demounting. In addition, it removes cleanly from the cushioned sleeve surface.
Recommended Applications
Mounting flexographic print plates to cushioned sleeves or compressible sleeves
Keep the Presses Running and your Customers Coming BackFor decades, 3M products have been at work in paper mills and printing plants helping to improve the quality of the work that goes out and the efficient of how it gets done. From paper web splicing to plate mounting and packaging the finished job, you can rely on 3M for solutions and service throughout your operation.
0.005 inch (0.13 mm) double coated tape has the air release feature designed to allow air to escape from between the tape and the plate
Non-linered side of the tape is designed for mounting to compressible sleeves
Securely bonds the flexographic photopolymer plate to the compressible sleeve to prevent plate edge lifting during printing